Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-22-2002, 10:28 PM
|
#1 |
|
Registered Member
Join Date: Jan 1999
Location: Sugarland, TX
Posts: 458
|
jonnyk is right about being relative........
I have 60cc chamber Darts with fly cut pistons and I was able to run 9 psi with a chip. (Powerdyne 11lb pulley and their chip). I was also able to run 11 psi with a T-trim with a stock pulley BUT! When I went to a 2.85 blower pulley (13psi) I melted 2 piston. All of this was with 93 octane.
__________________
306DSS, AOD, T-Trim Vortech #3325 w/ driver 6.9882@100.33 1/8th |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ported e7's? | bailey_57 | Windsor Power | 28 | 07-15-2004 07:54 PM |
| 71 2v Cleveland heads on a mild 302 | crazypete | Windsor Power | 3 | 06-18-2004 07:05 PM |
| Whats the difference in GT40 and GT40P Heads? | RoushRacing6N17 | Windsor Power | 2 | 11-17-2003 11:52 PM |
| Price estimate for barely used Edel. Perf. RPM alum. heads w/ 2.02/1.60 valves?? | Simi Stang | Windsor Power | 13 | 11-03-2003 11:23 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |