Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-27-2002, 05:24 PM
|
#1 |
|
Registered Member
Join Date: Mar 2000
Location: Springfield, Ma, usa
Posts: 706
|
As far as grinding, you should only have to grind down the first 3 sturctual supports on each valve cover. you will also need to remove the baffle from the passenger side cover. Yes the baffle shields oil from going into the TB, but the shaft that comes off the valve cover is long enough where you won't have any problems. Check out the Crane site, there will be info there on how to adjust the rockers. rocker install
__________________
NewEngland Auto www.baystategearheads.com -91 Mustang Coupe, ex 4cyl (sold) -99 F150, 3" lift, 35" Procomps, Magnaflow exhaust |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| crane 1.7's installed, now need help on valve covers | Coupe50h | Windsor Power | 6 | 11-14-2002 09:12 PM |
| Really, really love my crane 1.7's | Coupe50h | Windsor Power | 6 | 11-14-2002 04:26 PM |
| Crane 2031 cam and Edelbrock intakes on, impressions..... | 93CobraR | Windsor Power | 4 | 05-23-2001 11:53 AM |
| puttin heads on tomorrow, any advice? | fiveohpatrol | Windsor Power | 7 | 04-28-2001 10:59 PM |