Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-27-2002, 09:25 PM
|
#5 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
DON'T CUT THE TUBE! Just coil it up under the dash or somewhere out of the way. Make sure you don't kink it though!
I kind of did the same with the temp sensor for my fan, you can see it in the pic. http://www.mustangworks.com/cgi-bin/...dia.cgi?2529+3
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| autometer gauge install | GhettoPop | Windsor Power | 10 | 03-18-2004 10:05 PM |
| Water Temp sender | Faster & Mor Furious | Modular Madness | 0 | 08-12-2003 07:43 PM |
| installing autometer oil press and water temp | Ieatcamaros | Windsor Power | 5 | 05-06-2003 08:45 PM |
| Just an FYI on AutoMeter Mechanical Water Temp Gauge Install | RED92LX50 | Windsor Power | 15 | 05-06-2003 08:12 PM |
| Elec. water temp guage ?s | blueneonman1 | Windsor Power | 4 | 05-23-2002 10:13 AM |