Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-28-2002, 01:51 AM
|
#11 |
|
NX dealer-man
Join Date: Sep 1998
Location: Peoria, Illinois
Posts: 977
|
...there is a hair-line crack down the center of the block in the lifter valley, which allowed the cam bearings to fall out of their respective locations... I didn't get any good pictures of the top of the block, the crack was difficult to see on the computer screen... might try again tomorrow. I have my hands full getting all of the small stuff taken care of. It should all start falling together in a few months.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AFR 165's or other heads with cam and stock induction | Mustang_GT_90 | Windsor Power | 27 | 11-25-2002 03:01 PM |
| What makes a Small block a Small block and a Big Block a big block? | gtsr515 | Windsor Power | 13 | 05-20-2002 10:25 PM |
| Underhood Conical K&N vs. Stock Airbox with K&N | jimberg | Windsor Power | 11 | 08-31-2001 02:36 PM |
| 347 Cranks, Stock block | richs8750 | Windsor Power | 0 | 08-26-2001 08:31 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |