Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-28-2002, 02:24 AM
|
#2 |
|
The Redneck James Bond
Join Date: Sep 2000
Location: Fayetteville NC
Posts: 1,707
|
Not sure of your cam specs, but I'm willing to guess that its a Low To Mid Range cam. With the C4 ratio's though, I'd go for a little Lower Rear Gear. Sounds like a sound package. Also, not knowing your cam specs, its hard to say if your carburated right or not.
__________________
64 1/2 "D" code Red Mustang Coupe. Red Baron, 2000 Perf Red Mustang GT. 5spd. Stage 2 CNC heads with Large Valves, Comp Cams (270-274 dur .550 lift), Forged Crank, DRP pistons, Manly H-beams, Pro M 87 mm Mass Air, 24lb Inj, 75mm TB, Plenum Spacer ,Long Tube Headers, Homemade H-pipe, 2 chamber Flows, 4:10's, Steeda Tri-Ax, LKW 70/30's, Eibach Drag Springs, Steeda SubFrames, Battle Boxes, Rear Girdle, Adj uppers, Alunimum Drshft, Southside Lift Bars. Project Cars, 64 1/2 6cyl coupe, 1930 Model A Nostalgia Rod. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Typhoon Intake vs Edelbrock Performer RPM | lucheski | Windsor Power | 1 | 07-13-2004 12:54 PM |
| GM Engines | BLOCKER | Blue Oval Lounge | 2 | 04-13-2004 12:35 AM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Experience with Edelbrock RPM Package | jim_howard_pdx | Windsor Power | 0 | 10-27-2002 01:10 AM |
| flow numbers on edelbrock rpm intake? | Mach 1 | Windsor Power | 10 | 02-07-2002 09:20 AM |