Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-29-2002, 10:34 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: South Carolina
Posts: 58
|
TB and intake
I think stock 5.0 TB is 50 or 55MM. The explorer TB is noticable bigger.
The early 5.0 explorers 1996-1997 have the EGR passages even though they are not used. You can tell when you take the upper off. Look for the little black hole in the middle. Also you can get some good GT-40P or GT40 heads off those engines.
__________________
Bobasaurus 1987 LX 5.0 - Engine Rebuild now installed - 26290 Wonderful Miles so far Items now installed from the garage : GT-40p heads, Explorer Intake, FMS "P" headers, Crower 15511, SFI Balancer, 24#, SPEC Stage 1, T5z, 65MM TB, 77MM Pro-M, 255lph Pump |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| Installing Explorer Intake | MattwantsSpeed | Windsor Power | 16 | 09-01-2002 10:56 AM |
| I am new, and I dont know why Explorer Intake manifolds are so swell? | ChesteR | Windsor Power | 4 | 09-29-2001 02:29 AM |
| explorer intake | myred86gt | Windsor Power | 4 | 09-26-2001 12:18 AM |
| need advise on explorer intake | joey50gt | Windsor Power | 3 | 04-21-2001 07:22 AM |