Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-30-2002, 12:36 AM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
when u open the passanger side door, to your right is the kick pannel take off the kick panel. You will see the computer. You will need a 8mm socket to take the computer off of the inside of the car so it is easier to access the 60pin connector. the attached pic is the plug the wire is orange with i believe a small white line through it. Back probe it and make sure u got volts there if you dont you need a new computer(ecu)
later
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 Last edited by drtbiker; 10-30-2002 at 12:50 AM.. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Its painfully Obvious that I need to Relearn of few things. | Mercury | Blue Oval Lounge | 43 | 01-09-2002 08:59 AM |
| My New Flash Site | SpeedJunky | Modular Madness | 2 | 09-17-2001 02:16 PM |