Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-31-2002, 10:19 PM
|
#14 |
|
Registered Member
Join Date: Sep 2002
Location: Macomb IL
Posts: 42
|
Well right now im planning on getting tfs track heat heads and have them ported... I also plan on getting the track heat intake (im not sure about getting it ported though?) I am also going with 42lb injectors. And getting a custom cam from anderson ford motorsport.
I will put a 255 lph intake fuel pump... Im not sure if i will need another inline pump closer to the engine or not. My short block is made from scat crank, scat rods, and probe pistons. So i hope i can make 375 with my 331... I think i shouldn't have much of a problem with that setup? I already have a chip that can and has been reburnt before. Any comments? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help me reach my goal of 12.9 | mustangLX92 | Windsor Power | 18 | 05-01-2002 03:18 PM |
| Looking for easy way to reach 12's | Ares | Modular Madness | 8 | 01-09-2001 01:07 PM |