Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-03-2002, 02:53 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Clayton, CA USA
Posts: 116
|
Thanks for the advice Gearhead. I pulled the intake and found my problem. The gasket was blown between the rear water galley on the head and #8 intake runner.
This brings up another question. I'm running an Edlebrock Performer RMP intake. This manifold only has water galleys in the front. I'm thinking that the water pressure at the rear is what is wiping out my gaskets. This is the 2nd time this has happened. Does anyone else use a Performer RPM intake? And if so, what do you do about this problem?
__________________
'68 convert, 5.0 GT-40 Crate motor, C-4, Tri-Y headers, 3.25 rear gears |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surges at Partial Throttle | Comatose | Windsor Power | 12 | 05-02-2004 05:14 PM |
| Surging at higher speeds and RPM | Rosco | Windsor Power | 5 | 10-12-2003 11:08 PM |
| Car surges voilently and looses power in first? | jpumpkinn | Windsor Power | 3 | 07-31-2001 02:16 PM |
| Slight popping and Bucking at low speeds. | 87GTman | Windsor Power | 0 | 03-27-2001 01:47 AM |
| Shaking at freeway speeds | SirenSong | Classic Mustangs | 7 | 03-02-2001 08:04 PM |