Is my intake defective?

[HotRoddin]

Originally posted by srv1
that is normal. i have the Track Heat and it has two machined areas. i believe it is for fuel lines and distrubutor.

I don't know srv .. you look at the radius where the distributor goes and the first thing its gonna hit is that corner and they stopped short of the corner .... and as far as fuel lines go, if you layed a fuel line along that grove it would again hit that corner and the higher spot at the other end ?? I might buy clearence for something underneath the upper manifold, but even if it is, thats a pretty ragged lookin deep cut. Especially right into the bolt pad like that ???