Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-05-2002, 06:08 PM
|
#5 |
|
Guest
Posts: n/a
|
X, B, or E??
I'm not a 100% sure, but I think that the E-303 cam is the only one out of the three that you mentioned, that you can use without needing your pistons fly cut. I run the B cam w/ 1.72 rockers and love the set up. My motor pulls hard from 3000-6000rpms. My pistons have been cut though, during the build up of my current motor.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specs on my Camshaft | Kisner | Classic Mustangs | 2 | 08-01-2004 12:55 PM |
| ported gt40's and stock camshaft | chiaronate | Windsor Power | 11 | 04-14-2004 05:15 PM |
| Camshaft Question | SmokinStangGT | Windsor Power | 7 | 10-20-2003 12:40 AM |
| camshaft gains w/new stuff | 84LX89GT | Windsor Power | 5 | 06-30-2003 09:18 AM |
| camshaft selection | chiaronate | Windsor Power | 2 | 06-09-2003 02:17 AM |