MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 11-10-2002, 01:15 AM   #3
madokie
Registered Member
 
Join Date: May 2002
Location: okc okla
Posts: 5
Default 5-lug axle

83-92 ranger/bronko2 4cyl or 3.0 v6 is 7.5 rear end .driver side only! 4.0 rangers use 8.8 rear end axles same unless you are using drum brakes.4.0 ranger 8.8 rear uses 10 inch drum stang 8.8 uses 9 inch drum.for disk brakes ethier axle works fine.length is 29.156 inches .use tape measure from flange to end of axle and you will get 29.25.86-97 aerostar pass side also.from 1979 to 1993 FORD made one axle for stang 4-lug fits 7.5 or 8.8 same axle same strength.i make up 5-lug rear disk kits using mk-7 parts and ranger axles,all mods and welding done uses your stock p-cables,and brake lines with 2-3 port kit 300$ .250$ with out axles okc okla 405-943-8476
__________________
FORD beating jap crap since1941
madokie is offline   Reply With Quote
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
5 lug conversion stanger9219 Windsor Power 2 02-25-2004 11:31 PM
What all do you need to do rear disc conversion w/ SN95 Parts KG88GT Windsor Power 1 07-29-2003 01:45 PM
questions about maf conversion spankaveli Windsor Power 10 10-19-2002 02:46 PM
5 to 4 lug conversion mike_navigator Blue Oval Lounge 7 08-14-2002 11:17 PM
mass air 87GT conversion greydan Windsor Power 3 01-02-2002 07:57 PM


All times are GMT -5. The time now is 09:30 PM.


SEARCH