A/C Delete....Can I remove the condenser & the accumulator??

fordgasm · 06-22-2001, 12:22 PM

Yep, I removed the air pump sometime ago. I did not notice any difference after removing it but did not expect to. The drag from the air pump is minimal.

As far as removing the pump, it's pretty much a simple removal. Let's see if I can remember the high lites. You have to remove the cross over tube at the back of the heads and plug the holes in the heads. Remove the tube that goes to the H pipe, I installed an off road H pipe and plugged the connection for this tube. Plug any vacumn lines, removed EGR and put a plate over the opening. Remove the canistor and it's lines, I'm sure I missed something but that's pretty much it. I have heard some say they had problems getting check engine light and codes after removing the EGR but I have not. I also installed a phenolic spacer inbetween the upper and lower intake that plugged the port for the egr.

My car is a fair weather car and I did these mods originally to remove weight for drag racing. As it turns out it also improved the appearance under the hood. For an everyday street car it may not be worth the while, and if you have to pass emissions removing these items will be a problem and can be illegal.

Good luck

------------------
fordgasm
CLICK HERE to see my 87 GT

[This message has been edited by fordgasm (edited 06-22-2001).]

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to remove belt tensionner pulley (picture inside)	White GT	Windsor Power	5	06-18-2004 06:37 AM
Air Conditioner Installation	dvh1	Classic Mustangs	2	06-19-2003 02:03 PM
remove hunk of metal near rear pumpkin?	Simi Stang	Windsor Power	2	12-05-2002 06:27 PM
power steering delete and short belt routing?	matt cook	Windsor Power	4	05-12-2001 07:54 PM
How to remove door panel in '89 5.0L?	Gautam	Windsor Power	1	01-12-2001 03:14 PM

06-22-2001, 12:22 PM	#1
fordgasm Registered Member Join Date: Jan 1999 Location: Clayton, North Carolina, USA Posts: 803	Yep, I removed the air pump sometime ago. I did not notice any difference after removing it but did not expect to. The drag from the air pump is minimal. As far as removing the pump, it's pretty much a simple removal. Let's see if I can remember the high lites. You have to remove the cross over tube at the back of the heads and plug the holes in the heads. Remove the tube that goes to the H pipe, I installed an off road H pipe and plugged the connection for this tube. Plug any vacumn lines, removed EGR and put a plate over the opening. Remove the canistor and it's lines, I'm sure I missed something but that's pretty much it. I have heard some say they had problems getting check engine light and codes after removing the EGR but I have not. I also installed a phenolic spacer inbetween the upper and lower intake that plugged the port for the egr. My car is a fair weather car and I did these mods originally to remove weight for drag racing. As it turns out it also improved the appearance under the hood. For an everyday street car it may not be worth the while, and if you have to pass emissions removing these items will be a problem and can be illegal. Good luck ------------------ fordgasm CLICK HERE to see my 87 GT [This message has been edited by fordgasm (edited 06-22-2001).]