Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-13-2002, 03:50 PM
|
#22 |
|
Registered Member
Join Date: Mar 1999
Location: Amarillo, Texas, USA
Posts: 780
|
Amen to that. I guess feelings run pretty deep on this particular subject even after all the years it's been haggled over. It ws a good post, I laughed my arse off when I read it.
__________________
1986 four-eyed LX coupe, 358 Cleveland, Tremec TKO600/centerforce clutch, dish cut Probe forged pistons, comp cams hyd.roller cam, .579/.588@224/230, Edel.performer, 670 holley street avenger, CPR custom built long tubes, ported and polished 4bbl heads, manley valves, beehive springs, MSD peo-billet dist/MSD6AL, fluidamper, 5 lug conv. with 17x8 bullits there's more but it's still not finished yet. Oh, and the oldest boy is turning his 89 GT into a FFR cobra this next summer. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Control Arms?Does anyone have any recommendations on rear control arms? Do I really n | schizcat | Windsor Power | 5 | 08-28-2003 09:53 PM |
| granatelli lower control arms are junk! | sn95gt19 | Windsor Power | 9 | 07-02-2002 09:37 AM |
| Rear upper control arms | red82gt | Corner Carvers Delight | 2 | 08-01-2000 11:10 AM |
| Traction Control | Eminent18 | Modular Madness | 5 | 05-22-2000 06:44 PM |