Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-18-2002, 11:28 PM
|
#5 |
|
Registered Member
Join Date: Dec 2001
Location: corinth miss
Posts: 19
|
CAM SPECS!
here is the cam im running->LUNATI SOLID ROLLER
.691 in .668 ex dur @ 50 .264 in 276 ex trickflow said the springs that come on these heads or alot better than some of the older ones, and or not as hard on the valve trane.
__________________
Billy P. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Anybody ever use solid roller lifters in stock block? | mikew88gt | Windsor Power | 6 | 03-06-2003 05:26 PM |
| Solid, Hydraulic, Roller, Non-Roller... Pros and Cons | 2FastLX | Windsor Power | 10 | 12-24-2001 10:54 PM |
| Solid roller cam? | Five0 | Windsor Power | 14 | 11-30-2001 05:36 PM |
| How to change from a roller to solid?? | Smokedawg | Windsor Power | 3 | 10-04-2001 11:03 AM |