Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-21-2002, 12:57 PM
|
#1 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
IF you can route the belt without rubbing or reversing the direction of pulleys... then its ok to do.
You will have to deal with the h-pipe tube. Either you can cut it off and crimp it shut... and then deal with the back of the heads with pipe plugs to block them off too. Personally, I needed the dummy pulley cause of the S-trim..  and the old h-pipe was like this:  and the heads had the pipe plug from Home Depot: 
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cobra smog delete | jwhite1993 | Windsor Power | 1 | 12-04-2003 04:41 PM |
| Smog Pump Confusion | Evil Joe | Windsor Power | 1 | 03-23-2003 08:04 AM |
| Smog pump delete........Any ET gain???? | Dark_5.0 | Windsor Power | 2 | 07-31-2001 09:52 PM |
| PLEASE HELP!! Do I need the smog pump system to pass dyno emissions ?? | Stang_ROTY | Windsor Power | 5 | 07-02-2001 01:09 AM |
| smog pump delete | DemonGT | Windsor Power | 3 | 05-15-2001 09:09 PM |