Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-23-2002, 07:01 AM
|
#5 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I'm not to worried about the heads right now cuz there gonna be replaced by gt40p's within the next year. When i get them im gonna do a port/polish job on them before i put them on. I just want to get the intake all prepped so when i get the heads later i don't have to worry about the intake at all.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| question on porting | 93GTDIN | Windsor Power | 17 | 02-15-2003 07:05 AM |
| Home electrical question.. | 95mustanggt | Blue Oval Lounge | 8 | 08-28-2002 05:38 AM |
| home porting E7's | Skywalkr57 | Windsor Power | 4 | 07-30-2002 06:08 PM |
| Specific ?'s on home porting | 89lxinwky | Windsor Power | 2 | 04-27-2002 03:58 PM |
| home intake porting | jerryIII | Windsor Power | 2 | 06-15-2001 04:13 PM |