Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-04-2002, 09:50 AM
|
#2 |
|
motors done......woohooo
Join Date: Mar 2002
Posts: 799
|
i think 350hp would be the very best that you can get out of the kit. a buddy of mine put the excessive motorsports holley stg2 kit on his car, and ran a best of 13.20. that was on a tired short block though. i think you would be better off with edelbrock preformer heads, or out of box trick flows if you were going to leave your short block stock. have heard nothing but good about the intake, but i have never run one. personally i would recommend trick flow components..........just my .02
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM Package | jim_howard_pdx | Classic Mustangs | 2 | 10-28-2002 04:57 PM |
| Experience with Edelbrock RPM Package | jim_howard_pdx | Windsor Power | 0 | 10-27-2002 01:10 AM |
| Road Demon vs. Holley Avenger | Rev | Blue Oval Lounge | 5 | 09-12-2001 08:57 PM |
| Well I did a compression test and it doesn't look goo for my Holley heads... | Rick 91GT | Windsor Power | 6 | 02-20-2001 07:43 AM |