Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-04-2002, 03:00 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
In theory it could work if you installed the 19 lbs/hr sampling tube into the housing. I am not so sure how accurate it would be. You might want to call up Pro-M or who ever calibrated your MAF sensor.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should I add a cold air system to the C&l meter? | v8thunder | Modular Madness | 5 | 06-23-2003 01:40 PM |
| A rear housing is a rear housing? | GodStang | Windsor Power | 2 | 02-23-2003 10:35 AM |
| Mass airflow meter # Questions? | tomcat_37096 | Windsor Power | 1 | 11-16-2002 04:55 PM |
| Problem with Pro-M MAF meter?!?! | HiFlow5 0 | Windsor Power | 4 | 09-13-2002 01:35 PM |
| blow thru mass air meter? | PSI GUY | Windsor Power | 1 | 02-07-2002 09:16 AM |