Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-17-2002, 10:07 PM
|
#3 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
It'll probably be the Fel pro 1250 intake gasket. My heads were opened up to the 1250. I've currently got 1262's on it though because I blew out my silicone end seal and noone had a 1250 that day so I figured that at least it was big enough. works fine.
Just wait until you get the heads and then measure.
__________________
393W: AFR 205's, hydraulic roller, TKO600. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| blown head gaskets!!!! (read) | 11secondGT | Windsor Power | 9 | 08-27-2002 08:54 PM |
| which gaskets to run with Holley intake edelbrock heads | NewAge 5.0 | Windsor Power | 3 | 01-26-2002 04:38 PM |
| lower intake gaskets? will they work? | DemonGT | Windsor Power | 3 | 06-08-2001 06:40 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |
| Boss 429 head gaskets!! | 93CobraR | Classic Mustangs | 4 | 03-13-2000 07:28 AM |