MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Heads/Intake swap finished! Small prob though...
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-20-2002, 05:51 PM   #5
Agent_4573
Registered Member
 
Join Date: May 2002
Location: New Jersey
Posts: 375
Default
That is the engine temp sensor. There like 7 dollars at napa and the wire that plugs on top of it is your sensor wire. I replaced mine about 2 months ago when my gague was acting up.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression.

If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout.

RICER HATERS CLUB MEMBER 87!
www.ricehatersclub.com
Agent_4573 is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Just finished the AOD to T-5 swap in my 90 GT!!!!!!!! zepherman Windsor Power 6 10-29-2001 03:46 PM
Finally finished head/cam/intake swap TJR Windsor Power 2 09-15-2001 09:15 PM


All times are GMT -5. The time now is 12:49 PM.

Archive - Top

SEARCH