Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-01-2001, 12:10 AM
|
#7 |
|
Registered Member
Join Date: Jun 2001
Location: new castle pa
Posts: 32
|
sounds like the clutch is not disengaging completly how far of the floor does it catch
when its in first does it want to move with the clutch fully depressed and no brake check under the dash theres a plastic rachet mechanism that self adjust the clutch check it out make shure its not broke or stuck pull the pawl that holds the rachet mechanism back away from it the press the petal it should self adjust correctly if it seems bad go aftermarket i have t-5 in fbird and stang never had that happen and it not be the clucth but it could happen |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting ready for FFW...uggh | Topless In Texas | Racer's Club House | 0 | 05-02-2003 11:05 PM |
| over drive button | silverv6 | Stang Stories | 7 | 01-09-2002 11:58 PM |
| Hard drive failure=data recovery efforts | andy669 | Blue Oval Lounge | 5 | 01-07-2002 09:55 PM |
| My Friend, Tim C, let me DRIVE HIS CAR!!!! | Mercury | Blue Oval Lounge | 0 | 10-13-2001 01:25 AM |
| Dont 99+ GT's have Alunimum drive shafts? | Mercury | Modular Madness | 5 | 05-15-2001 12:33 PM |