Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-05-2001, 10:42 PM
|
#7 |
|
Registered Member
Join Date: Feb 2001
Location: winnipeg , manitoba , canada
Posts: 83
|
These cars seem to run very well with very little hooked up. I just fabricated a half sheet metal-half cast intake for my horse, in the process, i left behind every stinking piece of emissions there was. The car has not run so well in a long time. Even with poor o2s in (going to buy them this weekend) it still runs great , idles good, goes like hell , especially from 3000-6000. Just dont forget to plug all of the vaccuum lines to these things you remove.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve cover question | Stang951 | Windsor Power | 1 | 03-27-2004 11:57 PM |
| EGR Valve Question. | Bobby L | Windsor Power | 1 | 08-22-2002 02:23 PM |
| master cylinder and prop valve question | shelby2 | Classic Mustangs | 1 | 07-05-2002 05:32 PM |
| EGR valve question? | 84LX89GT | Windsor Power | 3 | 09-07-2001 02:09 AM |