Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-05-2003, 10:53 PM
|
#5 |
|
Registered Member
Join Date: Jan 2003
Location: In front of this thing
Posts: 34
|
Ive got a set of push rods from a non roller motor Im going to measure, if they are to tfs' spec Im going to stick them in, not sure how much thats hurting me, other than wore my valve guides out! But yeah, a guy here in town has a car about like mine but has police lights newer front clip and a cage with a 306 like mine, only he has a x303 and gasket matched e7's and hes going mid 12s motor and mid 11s on a 100 shot, so something is screwy
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |