Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-05-2003, 11:36 PM
|
#7 |
|
Registered Member
Join Date: Jan 2003
Location: In front of this thing
Posts: 34
|
My best 60s....
26x10 Et Street 1.8 26x10 Et Drags 2.2 275/40/17 BFG Drag Radials 2.0 Now then, I talked to a guy off hardcore 5.0 a bit ago. On my push rods, the ones trick flow says to use with my heads are about a 1/4" longer approx. thats .250", subtract that off my .544 lift cam and Ive got didly squat! Less than a stock 5.0 cam! Which if you listen to my car sit and idle, it sounds like it has something more like a stock cam than what I really have. So with this info, Im going to check push rod length tomorrow, if I dont have the 6.750" length they say, Im going to stick them in and try that, that thing may really kick, that could be the little kink thats held me back for a year! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |