Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2003, 01:58 PM
|
#8 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
The C&L uses the stock ford MAF sensor, it uses calibration tubes to "trick" the computer. The pro-M's are ussually recalibrated and should be more accurate, at least in theory. I have been using a C&L 76mm for a while and have had no problems with it. My car idles good and runs great.
Someone correct me if I am wrong, but I think the 73mm was discontiued.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Group Purchase-Mass Air Meters | BlackSunshine | Corner Carvers Delight | 0 | 11-24-2000 02:01 PM |
| Group Purchase-Mass Air Meters | BlackSunshine | Racer's Club House | 0 | 11-24-2000 02:00 PM |
| Group Purchase-Mass Air Meters | BlackSunshine | Small Ponies | 0 | 11-24-2000 01:59 PM |
| Group Purchase-Mass Air Meters | BlackSunshine | Modular Madness | 0 | 11-24-2000 01:57 PM |