Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-10-2001, 03:54 PM
|
#3 |
|
Guest
Posts: n/a
|
I would also suggest using a braided line, not the plastic one that comes with the gauge. Those tend to leak.
------------------ 91 coupe 3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm cobra intake,edelbrock heads,B303,1.72 rr's 36lb inj's,tremec, & a Paxton NOVI 2000!!! 11.020 @128.95 on BFG Drag Radials (275/60/15) |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: PKRWUD: Compression Test Results | 95mustanggt | Windsor Power | 13 | 06-22-2004 07:34 AM |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| mech oil pres gauge | GhettoPop | Windsor Power | 1 | 01-15-2004 10:14 AM |
| Boost Gauge Questions | SleeperGT | Power Adders | 3 | 10-01-2003 12:39 PM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |