install on ron davis alum radiator????

Rick 91GT · 07-11-2001, 02:48 PM

I have one installed on my car, if you don't get that Down's hold down you will need to clearance the stock brackets so they work, as far as retaining the factory shroud you will need to drill two holes in the top lip to bolt the shroud in and then I just used the 2 clips that came from the bottom and clipped the shroud to the edge of the bottom lip on the radiator and it held up fine. Now since I have a electric fan the shroud is long gone... you will need to pull the bottom hose of to drain the fluid since it doesn't have a pet-cock. It worked great for me and was a very nice qaulity piece, cools great!

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! FIRST TIME OUT 12.16@111 WHEELS-UP

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Overheating...was it radiator sealer?	crazypete	Windsor Power	19	06-17-2004 08:20 AM
New Gears, Install, and Questions	B2r3y	Windsor Power	6	02-21-2003 05:00 PM
summit race radiator	lx5091	Windsor Power	5	09-01-2002 05:30 PM
Radiator/ Fan Shroud	Kamaro Killer	Windsor Power	8	05-20-2002 02:13 PM
Engine Shifting into radiator and also clucth broke	Stuffie0912	Classic Mustangs	2	12-03-2001 03:26 AM

07-11-2001, 02:48 PM	#1
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	I have one installed on my car, if you don't get that Down's hold down you will need to clearance the stock brackets so they work, as far as retaining the factory shroud you will need to drill two holes in the top lip to bolt the shroud in and then I just used the 2 clips that came from the bottom and clipped the shroud to the edge of the bottom lip on the radiator and it held up fine. Now since I have a electric fan the shroud is long gone... you will need to pull the bottom hose of to drain the fluid since it doesn't have a pet-cock. It worked great for me and was a very nice qaulity piece, cools great! ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! FIRST TIME OUT 12.16@111 WHEELS-UP