Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-24-2003, 04:24 PM
|
#1 |
|
Registered Member
Join Date: Nov 2000
Location: INDIO CA USA
Posts: 141
|
Just one more stupid question, how did all you support the engine when the k-member was out? I really want to avoid pulling the motor, cause I just put it back it about a week ago.
I figure an engine crane is just in the way. I know they make those support bars that go from fender to fender, but is there an easier way?  Thanks
__________________
88 Notch Natually aspirated 306 600 carb Edelbrock Victor Jr. Intake and Performer RPM heads 11.5 comp. ATI C-4 8" 4200 stall 4:10's 28x10.5 M/T MAC longtubes/prochamber Dynomax Race magnumss dumped, Caged and ready to go!!! 11.8@115 And remember friends don't let friend drive MOPARS!!! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| K member Question | techsan | Windsor Power | 3 | 03-20-2003 10:04 PM |
| tubular k member/ motor mounts? | sn95gt19 | Windsor Power | 0 | 12-04-2002 12:05 PM |
| best tubular k member? | PSI GUY | Windsor Power | 3 | 10-15-2001 03:46 PM |
| Just installed a D&D tubular K and am VERY dissapointed | TRAXX | Windsor Power | 0 | 03-24-2001 12:27 AM |