Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2003, 12:53 PM
|
#8 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
So basically what your saying Dark is that an intake spacer will not add any horsepower, but bring your peak horsepower to a lower RPM range? Or will it maybe add a little at the same time? Reason I am asking is because I am looking into that Phenolic intake spacer. Dont want to waste money ya know.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Porting lower intake?? Velocity vs. Flow | Dark_5.0 | Windsor Power | 1 | 11-11-2002 02:42 AM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| where can i get a 1'' intake spacer | Chevysucks | Windsor Power | 4 | 12-10-2001 02:29 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| cobra intake spacer? | DemonGT | Windsor Power | 11 | 05-05-2001 01:52 AM |