

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Factoy Five Roadster
Join Date: May 2000
Location: Sevier Co,Tennessee
Posts: 1,681
|
![]() Since you asked,
I would buy those parts from your friend and put them up. Then I would save my money to buy a 302 short block. Several different companies sell complete short blocks. Just tell tell them what heads/cam/compression you have or want to run. 750 double pumper, way too big. If your on a budget as most of us are. Look for a used complete late model 5.0 motor. The bigest bang for your buck would be some new rear end gears. Search the want adds for a 3.55/3.70 or about that. Simply change out the center section with the used one. Atleast this way while your saving for a motor, your rear end will be ready. You won't set any track records, but your car will have a lot more out of the hole, even with your two barrel. Frank
__________________
Frank |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
Header advice | mustangLX92 | Windsor Power | 8 | 11-09-2001 02:43 AM |