Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-28-2003, 10:27 PM
|
#5 |
|
Registered Member
Join Date: Nov 2000
Posts: 290
|
One final question. Apparently, every time I've changed the transmission pan I've either under or over tightened the bolts. Shop manual says 12-16 ft. lbs. Went to pick up a torque wrench and to my shock those things are $69 - $149 at Sears. I don't need one that bad. Any rule of thumb to determine when I've tightened the bolts 12-16 ft. lbs. I read somewhere on the Internet that once the bolt head touches the pan to only turn another 1/8 of a turn. That sound about right?
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speedometer Cable to Transmission O-ring | Kisner | Classic Mustangs | 3 | 07-06-2004 02:13 PM |
| C-4 transmission | 420nitro | Windsor Power | 1 | 12-11-2003 11:10 AM |
| Transmission Identification | danmnvik | Classic Mustangs | 2 | 06-10-2003 11:38 AM |
| My transmission problems | waynesutton | Small Ponies | 0 | 09-06-2002 01:36 PM |