Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-12-2001, 01:37 AM
|
#3 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Sorry, I don't really know. Just didn't want to leave you hanging. Is it a specific replacement for a mustang? Most race car stuff is all fabricated, meaning welding and cutting. I think it should go straight in. If the leaf spring mounts are in the stock location, it should bolt right up. The stock driveshaft will probably not work. If I remember right the 9 inch pumpkin sticks out further. Shortening or lengthening the driveshaft is no problem for any drivetrain specialist. You might want to put up a post in the Classic mustang section of this website. I don't think anyone here has much experience with 9 inch rear ends, cause the 8.8's can take a beating. Good Luck! Anyone else know?
------------------ 92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Urgent.....read This!!! | Kevin Price | Blue Oval Lounge | 15 | 02-05-2003 01:11 PM |
| URGENT Suggestions on Bearings & Rings | jim_howard_pdx | Windsor Power | 3 | 09-24-2002 09:12 PM |
| MAC Pullies OK, or would you recommend another? (a little on the urgent side) | 95mustanggt | Windsor Power | 3 | 05-24-2002 10:05 AM |
| Just Got gear installed!!!! Urgent | JamGtStang | Windsor Power | 9 | 04-17-2001 08:50 AM |
| Urgent, please help... | Nicks5.0 | Windsor Power | 2 | 01-23-2001 09:55 PM |