Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-02-2003, 04:08 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: Harrisburg, Pennsylvania
Posts: 379
|
crane sells different lock sets ,comp should too
had to get a different set for my crane springs to adjust my retainer hieght.......lock set should cost like 20$ set shims can be obtained at most michine shops for a couple of dollars a set
__________________
the "not so old",old guy 87 Mustang GT T-top >hanlon t-5, pro 5.0, centerforce clutch ,adj. cable/quatrant ,3.27s ,full 2 1/2 ex(off road H) adj. reg. ,e-cam ,70mm TB, cobra intake ,1.7rr ,ported/milled e7ets w/crane springs ,306 balaced/decked short block w/speed pro forged flat top pistons ...257rwhp/302rwt best et 13.7@102 (4/11 ) '80 Capri (future project,currently collecting parts for 351 moter) |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve spring retainer clip removal | Hozer 88GTConv | Windsor Power | 9 | 01-28-2004 11:18 PM |
| master cylinder and prop valve question | shelby2 | Classic Mustangs | 1 | 07-05-2002 05:32 PM |
| Update broken valve spring. | 92Rustang | Windsor Power | 5 | 12-20-2001 04:54 AM |
| EGR valve question? | 84LX89GT | Windsor Power | 3 | 09-07-2001 02:09 AM |