Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2003, 11:43 AM
|
#2 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
I would suspect the motor mounts for your shifter alignment problem, but not matter how bad they are, they wouldnt cause the pressure plate to rub the bellhousing.
Are you sure that its hitting it and not just the throwout bearing gone bad? If it goes away when stepping on the clutch, this wouldn't be the pressure plate then, since it does not move when the clutch pedal is pressed. Are you sure you put the clutch in the correct way with "engine side" facing the engine?
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CLUTCH PROBLEMS (Fork??) | drewmp28 | Windsor Power | 6 | 07-18-2004 11:51 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| '65 Mustang - Pull Away Problems | geordie | Classic Mustangs | 6 | 05-11-2002 04:46 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |