Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-07-2003, 01:41 PM
|
#3 |
|
Registered Member
Join Date: Jan 2003
Location: NJ
Posts: 12
|
Thanks for the input. That was on of the things it did, but since the bottom of the shield is not supported it may crack around the bolt that supports the top from vibration. Call me paranoid, but I made an short L shape braket that I bolt to two of the three threaded bosses with isolation bushing for vibration. Keeps everything straight and even and the cover is used to help keep the heat out and not to support the unit.
I want to put a supercharger on my car but my wife said she will leave me if I do. I am still thinking. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full dyno testing on the C&L Plenum, 75mm TB, C&L MAF | 91LX2Bfast | Modular Madness | 4 | 01-23-2004 07:09 PM |
| cobra?? IMRC/ injectors and C&L | mellow98cobra | Modular Madness | 1 | 07-18-2003 11:18 AM |
| Should I add a cold air system to the C&l meter? | v8thunder | Modular Madness | 5 | 06-23-2003 01:40 PM |
| C&L Clear sampling tube? | Falcons Talon | Windsor Power | 2 | 05-08-2003 08:14 AM |
| C&L install | OMAR | Windsor Power | 0 | 04-22-2003 11:32 PM |