Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-22-2003, 10:51 AM
|
#1 |
|
Sniffed too much n20
Join Date: Oct 1998
Location: Ont, Canada
Posts: 1,018
|
I ran Edel. with 1.90's and an F cam with stock pistons. Had around 9.4-9.5 compression. I ran 12.90's that way at 107 and change. I since switched to a TFS Stage 2 cam. If you're not taking too much off the heads I'd say you're fine with the cam clearances. Always check of course. I wouldn't go more than 0.030" because you'll reduce the chamber by roughly 6cc's then. They are 60 to begin with (Someone correct me if I'm wrong). That'll give you lots of compression then.
__________________
2002 Windsor Weekend Q16 Qualifier |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT-40X heads ? | Mustang_289 | Windsor Power | 9 | 09-30-2003 08:21 AM |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| question on EDEL heads ...6022 | vande97 | Windsor Power | 3 | 02-16-2002 03:19 PM |
| Heads and Cam....tough question | cyberstang5.0 | Windsor Power | 2 | 12-07-2001 09:22 AM |
| A general question about heads! | Thad | Windsor Power | 0 | 10-10-2001 11:17 AM |