Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-26-2003, 01:25 PM
|
#11 |
|
Registered Member
Join Date: Aug 2002
Location: SanAntonio, Tx
Posts: 957
|
I have to go look at my e7's heads, i think they have a #13 on them, but not sure yet.
When i removed the upper, i thought it was alot of vaccuum lines and stuff in the way, but after doing once, i can do it quick! now the lower, you will have to pull the distributor, try and mark it's position, it sometimes takes a minute to get the dist gear to fall in place, (i've never done this) but I read my haynes manual all the time, you need to get one, and also a torque wrench, would be good to have.
__________________
X-Texas highway patrol ssp 1990 coupe - exploder Gt-40 iron heads, Explorer intake, 19 lber's. E-cam. crane 1.7 rollers. 190fp. 75mm maf. 65mm tb, tubular subframe connectors, mac cai, Asp crank pulley, T-5, king cobra clutch, flowtech 1-5/8 unequals, mac X-pipe Frpp driveshaft, lakewood Lca's. race weight 3,160 12.69 @ 107.35, 1.71 60' 26x8.5 drag's 3.90 gear 13.20 @ 106.91 - 235/60/15 firestones 2.3 60' 3.27 gear |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| Need advice on a 31 spline Upgrade! | chickendreamer | Windsor Power | 1 | 06-06-2003 07:20 AM |
| 87-93 GT 3rd Brakelight: Bulb part # | ponyboy25 | Windsor Power | 5 | 04-13-2003 08:48 PM |
| Need advice. Would like to upgrade to 306-351 | NYC1 | Windsor Power | 16 | 07-11-2002 12:23 AM |
| NEED ADVISE-Which Upgrade should I do first? | jpumpkinn | Windsor Power | 3 | 11-27-2001 12:51 AM |