Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-26-2003, 03:38 PM
|
#14 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
DAMN
 I would have put the 4.10's on instead of the 3.73's if I was a forum member here before I did the gear swap. Thanks for the info and schooling Bill. Just out of curiosity, what is your rpm range at 65 mph? Also, with the 4.30's whats the top speed you can get in first and second gears?
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|