Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-26-2003, 10:44 PM
|
#1 |
|
Registered Member
Join Date: Nov 2001
Location: Sunny, Hot, Sebring, Florida
Posts: 725
|
injectors/MAF
No an 80 won't be too big, BUT 24 pound injectors are a waste...there barely better than 19's, you need to go to 30's at least, calibrate the MAF once and build on that.
An 80 may give you a little driveability problems but thats part of modifying a stang ya know. Jay
__________________
Remember...2nd place is 1st place for losers! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 80mm MAF on a Stock 5.0 ?? | Katmandu | Windsor Power | 2 | 07-20-2003 07:18 PM |
| WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
| cheap mafs at vortech | 7up | Windsor Power | 1 | 02-05-2002 03:14 PM |
| C&L 80mm MAF | Laser Red '01 GT | Modular Madness | 6 | 06-21-2001 11:51 AM |
| PIH kit & 80mm MAF | HAITHAM | Windsor Power | 3 | 02-13-2001 08:38 AM |