Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-28-2003, 01:12 AM
|
#5 |
|
Registered Member
Join Date: Sep 2002
Location: Ponte Vedra Beach, FL
Posts: 122
|
After the stock Vortech install the car dyno'd at 313 rwhp and 370 rwtrq. Car ran a best of 106 mph at 13.0. I had a custom Diablo chip (not dyno tuned) and Anderson Powerpipe installed and the car ran 111 mph @ 12.6. I didn't have it dyno'd since these latest upgrades so the question is how much hp is 5 mph worth? I'm guessing I am currently running about 360 rwhp or so.
Could long tubes introduce any sort of detonation issue on the car (I just went through a lot of back and forth getting my chip set right for the car....clean up major driveability and detonation issues) and I really don't want to go through that again if adding long tubes could would require a new chip program.
__________________
'00 GT 5-spd Vortech S-Trim 3.1" Pulley Paxton Air-to-Air Aftercooler 90 mm MAS 42 lb injectors Cobra Fuel Pump 70 mm AccuFab Throttlebody C & L Intake Plenum 2 1/2" X-pipes Anderson PowerPipe MagnaFlow Mufflers Diablo Custom Chip 3.73's Steeda Lower Control Arms 358 rwhp (Mustang Dyno) New Track Times Coming Soon |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BBK Headers on TFS Heads.. Problem? | ChunkFunky | Windsor Power | 6 | 02-28-2003 03:37 PM |
| Leaking headers! | 89droptop | Windsor Power | 3 | 11-12-2002 01:18 PM |
| headers and O2 sensor | DemonGT | Windsor Power | 8 | 03-12-2001 06:24 AM |
| Pics of 1 3/4 Hooker Long Tubes #6227 | 8850 | Windsor Power | 5 | 01-30-2001 06:41 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |