Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-12-2003, 06:24 PM
|
#1 |
|
Registered Member
Join Date: Oct 2002
Location: San Antonio, TX
Posts: 7
|
i was under the impression that the stock T/B was 63mm on the inside. oh well, i replaced mine with a Ford SVO 75mm and it made a noticable amount of difference. if you are doing a straight swap then the 99 T/B will be fine. if the PI heads are going to be P&P, then you definitely want to go bigger. what about your MAF? just something to think about. good luck.
__________________
JV 98GT aka Holly 02 bullitt motor jms performance chip - program 2 steeda tri-ax shifter ford motorsport 9mm spark plug wires accel super coil packs pro-m 75mm maf ford motorsport shorty headers bbk h-pipe w/hi-flow cats - 2.5" flowmaster american thunder cat-back - 2.5" ford motorsport 3.73 rear end ford motorsport 150lph fuel pump kumho ecsta 712 - 255/40-17 |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 96 to 98 gt with a vortech blower ,, have a question 4 you ! | southernstang97 | Modular Madness | 8 | 07-31-2002 05:52 PM |
| 88 GT - rear exhaust question | Mustang_289 | Windsor Power | 3 | 09-11-2001 08:08 AM |
| 02 Gt or 02 Z28..that is the question. | Nick | Modular Madness | 11 | 07-16-2001 09:49 PM |
| Question: '97 Mustang GT | crumbie | Modular Madness | 7 | 05-08-2001 08:39 AM |
| 91 GT Sunroof question! | SHaFT7 | Windsor Power | 3 | 04-05-2001 08:04 PM |