Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-17-2003, 04:05 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
ok, I just started the car with both ends of the original wire disconected. The alternator was not charging so I am assuming the stator wire gets its power form the original wire. I reconnected it on the soleniod, and left the other end disconnected. Now thev volt meter reads around 14 volts so the alternator is now charging. Can someone please confirm this is the right way to do it? I am also replacing the fuse link with some 10 gauge since it is falling apart. Thanks.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Alternator wiring help | 1968FastbackN20 | Classic Mustangs | 0 | 10-08-2002 11:56 PM |
| 3G alternator wiring... Need help | Bad89stang | Windsor Power | 4 | 10-07-2002 01:54 PM |
| 86 V6 - V8 conversion help (mainly wiring related) | EazyE-CPT | Windsor Power | 2 | 09-12-2002 02:12 PM |
| Can I use the front wiring harness from my V6 on my V8? | EazyE-CPT | Windsor Power | 0 | 08-19-2002 11:42 AM |
| wiring up alternator | 65modified | Classic Mustangs | 2 | 06-16-2002 05:06 PM |