Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2003, 03:13 PM
|
#2 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
That is not normal or good. Maybe the guy didnt shim it right for the new gears. I would have another shop listen to it and see what they think. If they say the other shop screwed up then I would see about having that shop fix it and send the original shop the bill. More than likely though they are going to make you take it back to who did the work and let them fix it. Good luck.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What kind of rear end do I have? | Stang_ROTY | Windsor Power | 3 | 01-29-2005 02:46 PM |
| Motor back together - strange noise???? | DZEE'S LX | Windsor Power | 13 | 03-15-2002 12:46 AM |
| Any tips on rear assembly/lower cntrl arm install? | LOCASH | Windsor Power | 1 | 04-30-2001 04:35 AM |
| 9inch rear end install | glxstang | Windsor Power | 3 | 02-05-2001 10:24 AM |
| Need help quick!!! Rear main seal install.... | TROYXTROY | Windsor Power | 5 | 01-26-2001 08:58 PM |