Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2003, 03:59 AM
|
#8 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
The screw part should be sticking out of the hole in the bottom of the control arm. Put the screw thing through the hole and then pivot the sping onto the upper perch. My guess is you either don't have it compressed enough or you haven't lowered the control arm far enough.
I put a set of eibach drag launch springs in my buddy's 99 GT and we had to really reef on the compressor to get it to compress enough.
__________________
393W: AFR 205's, hydraulic roller, TKO600. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front eibach pro-kit spring installation | mtv not bullets | Windsor Power | 1 | 01-05-2004 10:05 PM |
| Front Coil Spring Installation | Mac_5.0 | Windsor Power | 4 | 05-28-2003 11:09 AM |
| Front spring help, ASAP! | Chris_H | Windsor Power | 5 | 05-12-2003 07:12 PM |
| Front spring removal question... | BLACK85GT | Windsor Power | 6 | 01-17-2003 10:43 AM |
| Front spring and strut install | gray87GT | Windsor Power | 0 | 06-17-2001 05:54 PM |