Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2003, 02:07 PM
|
#2 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
From what I hear, the side exhaust is good for mostly looks only, not performance gains. What I was told is, they increse your back pressure as speed increases vice a rear exhaust which creates a suction as speed increases. Again, this is just what I was told by a performance shop tech, not from experience.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 04 Mach vs 03 Cobra | RBatson | Blue Oval Lounge | 20 | 01-13-2004 09:07 PM |
| thinki saw '93 cobra but not sure.....plz confirm this for me(description) | yelowjaket | Blue Oval Lounge | 5 | 06-09-2003 05:49 PM |
| What should I pay for a low mileage used Cobra Exhaust? | MonsterTrosity | Blue Oval Lounge | 4 | 10-22-2001 11:44 AM |
| 2001 Cobra Over Rated AGAIN!!!?!?!!! Wassup Ford? | KillaZ350 | Blue Oval Lounge | 24 | 06-29-2001 05:24 PM |
| I think I have found the tips for my side exhaust... | 88COBRA | Windsor Power | 0 | 01-17-2001 12:38 AM |