Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-06-2003, 07:21 PM
|
#1 |
|
Registered Member
Join Date: Feb 2003
Location: NJ
Posts: 81
|
Hey there my dad had the same problem with his carb and he did everthing and he found out that dirt was getting through the filter and getting into the carb and flooding it, like you said every time we would stop at a light it would stall. try to check the filter he doubled it up and put 2 filters on and it works fine now.
__________________
93 GT 351 to 393 stroker, GT40 upper and lower intake, GT40X Turbo Swirl heads, holley 80mm throttle body, 255 fuel pump, 42 lb injector, JE pistons, Comp cam, comp lifters, comp pushrods, comp springs, crane Roller rockers. Trick flow Crank Shaft, comp Timing chain. MSD 7 series ignition, msd hvc2 coil, MSD timing adjust, MSD Pro billet Dis, Hooker long tube, Off road H pipe 1 chanber race flows, 4.10 gears, Vortech cooler and T-Trim with a 25lb boost AND LOTS MORE. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock Carb | Elvis | Classic Mustangs | 5 | 08-31-2004 10:31 AM |
| 600CFM Edelbrock carb | 7SecYaRight | Windsor Power | 8 | 10-09-2003 01:23 AM |
| Generic Rebuild kits for Edelbrock 750 carb | SuperIrish | Windsor Power | 3 | 05-10-2003 01:07 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |
| How to jet an Edelbrock 1405 Carb ? | FordFasteR | Windsor Power | 2 | 08-10-2001 03:54 AM |