Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2003, 11:25 AM
|
#5 |
|
Registered Member
Join Date: Feb 2003
Location: Bradenton, FL
Posts: 4
|
Boring, what to do
The machinest said the little marks I see are OK, and when he hones it more of them will clean up. I took the edge of a rasor blade and can not feel dips, so I know they are not deep. Are a few tiny spots OK or will this kill the rings faster than normal.
My choices are: Bore it to .060 Build it like it is I have not asked yet, but I think you can sleave it Buy the other block at the Junkyard and start over |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| dont know a thing about stroking or boring | stanger9219 | Windsor Power | 3 | 03-23-2004 09:28 AM |
| The going rate for boring a cylinder | jruppert | Windsor Power | 3 | 11-21-2002 10:35 PM |
| Boring Block | GodStang | Modular Madness | 5 | 09-23-2002 12:38 PM |
| Another boring question for all of you.. | bobtodd | Windsor Power | 3 | 05-20-2002 10:31 PM |
| Boring Question ... the .030 Boring | SurfaRiver | Windsor Power | 2 | 04-28-2002 09:51 PM |