Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-14-2003, 07:39 PM
|
#2 |
|
Factoy Five Roadster
Join Date: May 2000
Location: Sevier Co,Tennessee
Posts: 1,681
|
If you stripped it down to where a welder could get to it with no problem. I don't think it would cost much at all.
If your not a welder I wouldn't tackle a frame as a first job. Probably pay more for the parts than the labor.
__________________
Frank |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sub frame connectors | 84GT350-1 | Windsor Power | 9 | 05-31-2004 10:07 AM |
| Sub frame connectors, roll cage ????? | 84GT350-1 | Windsor Power | 3 | 05-11-2004 09:59 AM |
| Sub frame connector recommendation? | 92LimEd | Windsor Power | 3 | 10-18-2002 09:19 PM |
| Launch.....hitting frame tunnel! HELP!! | Extremestang | Windsor Power | 4 | 08-14-2002 08:44 PM |
| Frame supports for an '85? | strawberryfield | Small Ponies | 0 | 01-01-2002 01:21 PM |