Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-20-2003, 08:16 AM
|
#2 |
|
Registered Member
Join Date: Apr 2003
Posts: 69
|
Is yours a mass air car?
If so: 1) Disconnect the battery (and the IAB valve) for 20 minutes. 2) Reconnect the battery (but not the IAB valve), start the engine and adjust the idle. 3) wait 2 minutes, connect the IAB valve, turn off all accessories, start the engine, let it idle for two minutes. 4) Shut off engine for two minutes. 5) Turn on all accessories, start the engine, let idle for two minutes. I don't know if this works for Speed Density cars.... Not sure but I don't think so! Phil |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| idle speed sensor | BOW TIE SMASHER | Windsor Power | 4 | 10-22-2002 09:56 PM |
| Idle problem 88GT Speed Density | chuck88 | Windsor Power | 9 | 07-07-2002 09:16 AM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| High idle speed out of no where. | SlowStang2 | Windsor Power | 9 | 07-11-2001 03:43 PM |
| paging:ALL SPEED DENSITY GURUS, E303=surging idle | slow87GT | Windsor Power | 7 | 02-14-2001 02:28 PM |